Mounting Sequence - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
12 - 5 Nm + 90° further
❑ always replace ⇒ Electronic Catalogue of Original Parts
13 - 5 Nm
14 - Transmission neutral sender - G701-
❑ for vehicles with start-stop system
15 - Reversing light switch - F4- , 20 Nm
16 - Sealing ring
❑ if present, replace ⇒ Electronic Catalogue of Original Parts
17 - Shift mechanism
❑ Gearshift forks
❑ disassembling and assembling
18 - Drive shaft and output shaft with bearing support for grooved ball bearings
❑ Always replace bearing support after removing ⇒ Electronic Catalogue of Original Parts
❑ pressing off and on bearing support
❑ Disassembling and assembling the drive shaft
❑ Disassembling and assembling the output shaft
19 - Reverse shaft support
❑ with support
20 - Reverse gear
21 - Screw
❑ for reverse shaft support -Pos. 17-
❑ M6: 5 Nm + 90° further
❑ M8: 25 Nm + 45° further
❑ always replace ⇒ Electronic Catalogue of Original Parts
4.6

Mounting sequence

Removing and installing cover for gearbox housing, clutch hous‐
ing, gearshift shaft with gearshift cover, drive shaft, output shaft,
differential gear and gearshift mechanism
Note
On gearboxes as of production date 06.09, the springs of the
sliding sleeve with synchronizer body for 3rd, 4th and 5th gear are
changed (the springs are longer), at the same time the synchron‐
izer ring for 3rd and 4th gear is changed as of this date ⇒
Electronic Catalogue of Original Parts .
Special tools and workshop equipment required
♦ Assembly stand - MP9-101-
♦ Pressure plate - MP3-406 (VW 401)-
♦ Pressure plate - MP3-407 (VW 402)-
♦ Pressure spindle - MP3-408 (VW 412)-
♦ Guide bolt - T10079-
♦ Gearbox mount - T30012 (3221)-
♦ Insert base - T10083-
♦ Washer - T10083/1-
118
⇒ page 132
⇒ page 135
⇒ page 135
⇒ page 144