Disassembling And Assembling The Gearshift Mechanism On The Gearbox Side (Gearshift Shaft Cannot Be Removed From Gearshift Cover) - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02R - Edition 08.2014
6.2 Disassembling and assembling the gearshift mechanism on the gearbox
side (gearshift shaft cannot be removed from gearshift cover)
Note
Grease bearing points and friction surfaces.
♦
Assign the grease via the ⇒ Electronic Catalogue of Original Parts .
♦
1 - Gearshift unit
❑ consisting of the gear‐
shift shaft and the gear‐
shift cover
❑ Parts cannot be separa‐
ted
2 - Reversing light switch - F4- ,
20 Nm
❑ Grease peg lightly with
grease for plug serration
of clutch disc -
G 000 100-
3 - Locking angle
❑ for setting the gearshift
mechanism
❑ removing ⇒ page 159
❑ installing ⇒ page 159
4 - Reversing lever
❑ Fitting position
⇒ "1.8 Summary of com‐
ponents - Control ca‐
bles", page 74
❑ Removing and installing
(Fabia II, Roomster,
Rapid NH)
⇒ "1.9.1 Removing and
installing plastic relay
lever", page 78 , (Rapid)
⇒ "1.11 Removing and
installing shift mecha‐
nism (Rapid) ", page 84
❑ after installing set shift
mechanism
⇒ "1.12 Setting the shift
mechanism", page 86
5 - Clip
❑ for relay lever with hole in the bearing shaft
6 - Gasket for gearshift shaft
❑ release with a screwdriver
❑ inserting ⇒ page 157
7 - 20 Nm
❑ always replace ⇒ Electronic Catalogue of Original Parts
8 - Gearshift lever
❑ insert in such a way that the interrupted spacing of the teeth matches the gearshift shaft
❑ may be replaced with the gearshift mechanism mounted
158