Repairing Clutch - Skoda FABIA II 2007 Workshop Manual

3

Repairing clutch

Special tools and workshop equipment required
♦ Counterholder -MP1-223 (3067)-
♦ Centering mandrel -MP3-475A (3190A)-
♦ Grease for the plug serration of the clutch disc -G 000 100-
(Gearbox removed)
Note
Before replacing the clutch disc and pressure plate fault finding power transmission - observe complaints
♦
of the clutch and clutch control
Replace the clutch discs and pressure plates if the riveting is damaged or loose.
♦
Assign the clutch disc and pressure plate in accordance with engine identification characters ⇒ Electronic
♦
Catalogue of Original Parts .
In order to reduce unpleasant odours if the clutch is burnt, thoroughly clean the clutch housing as well as
♦
the flywheel and the engine on the side of the gearbox.
Clean the drive shaft serration and hub serration on used clutch discs, remove corrosion. Apply a very thin
♦
layer of grease for plug serration of clutch disc -G 000 100- onto the serration. Subsequently move the clutch
disc up and down on the drive shaft until the hub fits smoothly on the shaft. Remove all excess grease.
The pressure plates are protected against corrosion and are greased. Only clean the thrust surface as
♦
otherwise the life of the clutch may be considerably reduced.
The thrust surface of the pressure plate and the clutch disc lining must fully rest against the flywheel before
♦
the screws are inserted. Only then may the fixing screws be inserted.
⇒ page 41 .
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
3. Repairing clutch
39