Removing And Installing The Clutch Pedal; Fabia Ii - Skoda FABIA II 2007 Workshop Manual

FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
1.4 Removing and installing the clutch ped‐
al; Fabia II 2007 ?
Special tools and workshop equipment required
♦ Pliers -T10005-
♦ Polycarbamide grease -G 052 142 A2-
Removing
– Remove the storage area on the driver's side ⇒ Body Work
⇒ Rep. Gr. 70 .
– Remove crash strut (if present)
– Remove clutch pedal switch -F36- , if present
⇒ Item 7 (page 9) .
Unlock the actuating rod/master cylinder from the clutch pedal as
follows:
– Pull clutch pedal slightly into the passenger compartment.
– Insert pliers -T10005- in the clutch pedal recesses.
– Press together both sides of the support inwards using the pli‐
ers -T10005- -arrows- and separate the clutch pedal from the
master cylinder.
– Removing the over-centre helper spring
– Put steering wheel in the lower position.
– Unscrew nut -A- and pull out screw from bracket (to facilitate
pulling out the screw, turn the steering wheel to the corre‐
sponding position).
– Remove clutch pedal.
Install
Installation is performed in the reverse order, pay attention to the
following points:
• Always replace self-locking nut ⇒ Electronic Catalogue of
Original Parts .
– The support -A- must be located on the actuating rod -B- of
the master cylinder.
– To click in the support, press the clutch pedal towards the front
wall in -direction of arrow-. While doing so, make sure it catch‐
es correctly in the support.
– Install the clutch pedal switch -F36-
– Install crash strut (if present)
– Install the storage area on the driver's side ⇒ Body Work ⇒
Rep. Gr. 70 .
Tightening torque
Clutch pedal to bracket
1)
Replace self-locking nut.
14
Rep. Gr.30 - Clutch
⇒ page 12 .
⇒ page 12
⇒ Item 7 (page 9)
⇒ page 12 .
1)
.
.
⇒ Item 20 (page 10)