System Error (S9Fx) - Mitsubishi Electric MELSEC iQ-R Series User Manual

4. DTS (Date and time setting)
<S2F31>(H→E)
A<TIME>YYYYMMDDhhmmsscc
<S2F32>(H←E)
B<TIACK>
*1 When data count in <TIME> is set to 16 and variable length setting is enabled, it supports the reception of the following three formats:
16 byte format (YYYYMMDDhhmmsscc)
14 byte format (YYYYMMDDhhmmss)
12 byte format (YYMMDDhhmmss)
*2 <TIME> can be set within the range from 0:00:00 on January 1st, 2000 to 23:59:59 on December 31st, 2079.

System error (S9Fx)

The SECS/GEM communication software provides the following error messages.
No. Name
1 UDN
(Incorrect device ID)
2 USN
(Unrecognized Stream Type)
3 UFN
(Unrecognized Function Type)
4 IDN
(Illegal Data)
5 TTN
(Transaction time-out)
6 DLN
(Data Too Long)
1. Incorrect device ID, 2. Unrecognized Stream Type, 3. Unrecognized Function Type, 4. Illegal Data, 6. Data Too Long
Example: S9F1
<S9F1>(H←E)
B10<MHEAD>
<S9F2>
(Unused)
5. Transaction time-out
S9F9
<S9F9>(H←E)
B10<SHEAD>
<S9F10>
(Unused)
S9F13. CTN (Conversation Timeout)
S9F13
<S9F13>(H←E)
<L, 2>
A<MEXP>
-<EDID>
<S9F14>
(Unused)
APPX
290
Appendix 3 Reserved Transactions
*1,*2
Transaction
S9F1(H←E)
S9F3(H←E)
S9F5(H←E)
S9F7(H←E)
S9F9(H←E)
S9F11(H←E)
The time data given in <TIME> is configured in the clock of the of the SECS/
GEM communication software pre-installed model module.
However, for a MELSEC-Q series SECS/GEM communication software pre-
installed model module, configure the time of CPU No.1 by the programmable
controller CPU because a multiple CPU system depends on the time zone of
CPU No.1.
Notification to the programmable controller CPU is performed according to the
setting.
The online status setting of the C Controller module with this transaction is
based on the SF code. Even if the transaction name differs from the name on
the left, the processing will be the same.
Description
Notifies that the device ID in the header of the received message is different
from the device ID set in SECS/GEM communication software.
The Stream code of a received message notifies of a lack of the definition at
the SECS/GEM communication software.
The Function code of a received message notifies of a lack of the definition at
the SECS/GEM communication software.
Notifies that the format of the received message from the host is different from
the message format set in SECS/GEM communication software.
Notifies that T3 timer (host response monitoring timer) time-out occurred.
Notifies that CA-SECS received an improperly sized message that cannot be
processed by SECS/GEM communication software.
The header of the received message (erroneous message) is configured to
<MHEAD>.
The header of the sending message (primary) in the timed-out transaction is
configured to <SHEAD>.
User definition of S9F13 is necessary.