Mitsubishi Electric MELSEC iQ-R Series User Manual page 167

SECS status message
Log to display the SECS status managed by the SECS/GEM communication software.
The following table shows the item content to be displayed.
Message
CIMREADY
CONNECT(Selected)
DISCONNECT(NotSelected)
Communicating
NotCommunicating
ON-LINE
OFF-LINE
SpoolEnabled
SpoolDisabled
SpoolActive
SpoolInactive
SpoolTransmitStart
SpoolTransmitFailure
SpoolTransmitComplete
PurgeSpool
ControllerClock-Changed
Precautions
The order of log output before and after a SECS status message may differ from the actual time series.
Description
CIM control is ready.
The line is connected.
Disconnection was detected.
Communication is established.
Communication is disconnected.
The mode transitioned to online.
The mode transitioned to offline.
The spool function is configured to
enabled.
The spool function is configured to
disabled.
Spooling has started.
Spooling has stopped.
Spool transmission has started.
An error occurred during spool
transmission, resulting in transmission
cancellation.
All spool transmission has been
completed.
The spool was purged.
The controller time was changed.
Notes
Output is enabled only when the SECS communication log output trigger is
not used (SECS logs are always acquired).
Indicates a Selected state for HSMS communication.
Indicates a Not Selected state for HSMS communication.
Indicates that the S1F13 transaction was successful.



The ON status of the Enable spooling relay is detected.
The OFF status of the Enable spooling relay is detected.


Triggered by S6F23 (Spooled data request) reception.
T3 timeout, line disconnection, etc.

Triggered by S6F23 (Spooled data request) reception or the use of the
spool data discard trigger.

7 BASIC FUNCTIONS
165
7.17 Log Output
7