Mitsubishi Electric MELSEC iQ-R Series User Manual page 48

C controller/c intelligent function module secs/gem communication software pre-installed model
Hide thumbs Also See for MELSEC iQ-R Series:
Table of Contents

Advertisement

Precautions
• To convert a project, it is required to use a newer version of the setting tool than the one in which the project was created.
• When opening a project which is created with the Japanese version setting tool in the English version setting tool, some
characters may be garbled.
• If a conversion fails, a target project will not be converted and will be in the state where a project is newly created in the
setting tool.
Version conversion
Upgrade the version of a specified project so that the project can be used in the setting tool which uses the conversion
functions.
This function is available in all module types.
: Conversion available, : Conversion not available
Conversion source project
Non-GEM version
GEM version
GEM advanced version
The following table shows the items to be converted. For items other than below, settings will be inherited from a previous
version project.
Item
Version information
Added functions
*1
Variable settings
*1 This item can be converted by the software version 1.33K or later.
7 BASIC FUNCTIONS
46
7.1 Management of Projects
Conversion destination project
Non-GEM version
Description
The version information of each setting file will be updated.
When new functions are added by upgrading the version, settings will also be added so that the functions can be used.
For the setting values, values when creating a new project in the upgraded setting tool will be set.
For functions added by the upgrade, refer to the following:
Page 299 Added and Changed Functions
When a value within the range has been set for the data count in a previous version project, the setting will be inherited
from the project.
The out-of-range value set for the data count will be changed to the maximum value that can be set.
Therefore, if a variable value exceeds the available number of characters, the value beyond the number of characters
set for the data count will be deleted.
For details on the variable settings, refer to the following:
Page 212 Variable definition
GEM version
GEM advanced version

Advertisement

Table of Contents
loading

Table of Contents