Communication Setting By Plc - Mitsubishi Electric MELSEC iQ-R Series User Manual

Communication setting by PLC

Series
MELSEC-Q series
MELSEC iQ-R series
Change the communication setting by the value acquired from the register.
The parameters of the communication method selected by "Port type" of the "Communication settings" screen can be
configured.
Window
[Setting]  [Communication Setting By PLC]
Displayed items
Item
Communication Setting by PLC
Device ID
Setting Request Trig
SECS-
HSMS
Operating procedure
1.
Start the SECS/GEM communication software.
During start-up, the current setting values of the SECS/GEM communication software are applied to the register.
2.
The register value is changed, and the setting trigger is configured to ON.
The setting value of the SECS/GEM communication software is changed by the register value, and the setting trigger is
configured to OFF by the SECS/GEM communication software.
When an invalid value has been configured to the register, the register value returns to the value before the change.
3.
Reset the programmable controller CPU.
7 BASIC FUNCTIONS
76
7.5 Communication Setting
SECS/GEM communication software
Non-GEM version


Description
Select this checkbox to change communication settings from a ladder program.
Configure the reference-destination register of the device ID value to be changed.
The Device ID parameter is necessary for both SECS- and HSMS.
Configure the trigger relay to apply setting information.
Configure the reference-destination register of the parameter value.
For the value to be stored to the register, refer to the following:
Page 77 SECS-I configuration
Configure the reference-destination register of the parameter value.
For the value to be stored to the register, refer to the following:
Page 77 HSMS settings
GEM version


GEM advanced version

