Mitsubishi Electric MELSEC iQ-R Series User Manual page 193

State Change
Window
[GEMFunction]  [Processing state]  [State Change] tab
Displayed items
Item
State Change 
Processing Section
Processing State
■Processing state numbers
For the processing state number to be stored to the processing state register, refer to the following:
*1
No. State/Command
1 IDLE
2 SETUP
3 READY
4 EXECUTING
5 PAUSE
32 SETUP
33 READY
34 START
35 COMPLETE
36 STOP
37 ABORT
38 PAUSE
39 RESUME
*1 From 6 through 31, specify any state as a user defined range.
Description
Set the replay used by the Programmable Controller CPU to notify SECS/GEM communication software
about the transition of the processing state.
The processor and processing state changes are reported when the trigger was detected.
Configure the register to notify the SECS/GEM communication software from the programmable
controller CPU of a processor number that changed its processing state.
This setting is reflected in the discrete variable ProcessChangePart.
For more details of values, refer to the following:
Page 216 Variables defined by default
Configure the register to notify the SECS/GEM communication software from the programmable
controller CPU of a processing state number that changed its processing state.
This setting is reflected in the discrete variable ProcessChangeStatus.
Notes
State variable ProcessState_part01
State variable ProcessState_part01
State variable ProcessState_part01
State variable ProcessState_part01
State variable ProcessState_part01
Setup command IDLE→SETUP
Setup completed SETUP→READY
Start instruction READY→EXECUTING
Processing completed EXECUTING→IDLE
Stop instruction
Switch to IDLE
Abort instruction
Switch to IDLE
Pause instruction PROCESS→PAUSE
Resume instruction PAUSE→PROCESS previous state
8 GEM COMPLIANT FUNCTIONS
8.6 Processing State Model Management
8
191