Canon imageRUNNER ADVANCE C3330 Series Service Manual page 200

• Manual setting : IP address, subnet mask and gateway address to be set
Information item 2
Is there a DNS server in use?
If there is a DNS server in use, find out the following.
• Primary DNS server address
• Secondary DNS server address
Information item 3
Is there a proxy server?
If there is a proxy server in use, find out the following.
• Proxy server address
• Port No. for proxy server
Information item 4
Is proxy server authentication required?
If proxy server authentication is required, find out the following.
• User name and password required for proxy authentication
● Network settings
Based on the results of the information obtained in 2) Advance preparations, make this machine network related settings.
See Users' Guide for detailed procedures.
CAUTION:
When changes are made to the above-mentioned network settings, be sure to turn OFF and then ON the main power of
this machine.
■ Steps to E-RDS settings
1. In the following service modes, initialize a set value of E-RDS.
Select COPIER > Function > CLEAR > ERDS-DAT and touch the [OK] button.
NOTE:
This operation initializes the E-RDS settings to factory setting values.
For the setting values to be initialized, see the section of
2. Perform installation or deletion of the CA certificate if necessary, and turn OFF and then ON the main power of this
machine.
• Installation of the CA certificate: Perform installation from SST or Remote UI.
• Deletion of the CA certificate: When the following operation is performed, the CA certificate in the factory setting is
automatically installed.
CAUTION:
After following procedure, the registered key and CA certificate are deleted, and only the CA certificate installed at the time
of shipment is registered.
It is therefore necessary to check with the user in advance.
1. Select (LEVEL2) COPIER > Function > CLEAR > CA-KEY and touch the [OK] button.
"OK!" is displayed if the CA certificate is initialized. When "NG!" is displayed, see the section of
page 192 to execute the remedy, and then perform initialization of the CA certificate again and check to see if the CA
certificate is initialized.
2. Turn OFF and then ON the main power of this machine.
CAUTION:
If a key and a CA certificate have been registered in order to use a function other than E-RDS, it is necessary to register
again from SST or Remote UI.
"Initializing E-RDS settings" on page
188
2. Technology
190.
"Troubleshooting" on