Installation - Mercury 25 EFI Service Manual

Installation

1. Install the power trim switch into the power trim switch housing. Ensure that the switch is secured in the housing with lock
tabs.
a
b
2. Route the power trim switch harness through the tiller handle and carry handle.
3. Install the power trim switch housing onto the throttle shaft.
c
4. Install the power trim switch harness clamp and screw. Tighten screw securely.
5. Attach the cover to the carry handle with three screws. Tighten screws securely.
6. Connect the power trim switch wires to the power trim relays. Refer to Section 5B ‑ Power Trim Electrical Circuit.
90-8M0105568 eng MARCH 2016
c
c
c
b
a -
b -
c -
c
13958
a
b
13956
a
© 2016 Mercury Marine
Power trim switch
Power trim switch housing
Lock tabs
a - Power trim switch and housing
b - Power trim switch housing mounting
clip
c - Throttle shaft
a - Power trim switch
housing
b - Power trim switch
harness clamp
c - Carry handle cover
screw (3)
13952
Tiller Handle
Page 7B-9