Mercury 25 EFI Service Manual page 343

10. Remove the steering shaft from the swivel bracket.
a
b
c
e
d
11. Remove the port clamp bracket to remove the swivel bracket.
a. Remove the tilt tube nut.
b. Remove the two power trim harness clamps.
c. Pull the harness through the hole in the clamp bracket.
d. Remove the snap ring and washer from the lower pivot pin.
e. Loosen the port clamp bracket clamp screw and remove the transom bolts from the port clamp bracket.
f. Remove the port clamp bracket.
g. Remove the swivel bracket.
a
c
b
e
f
Reassembly
1. Install the swivel bracket:
a. Install the swivel bracket to the tilt tube and starboard clamp bracket.
IMPORTANT: The tilt tube end with the fewer threads is assembled to the starboard side clamp bracket.
b. Attach the port clamp bracket.
c. Tighten the port clamp bracket clamp screw and install the transom bolts through the port clamp bracket.
d. Push the lower pivot pin through both clamp brackets.
e. Install the snap ring and washer from the lower pivot pin.
90-8M0105568 eng MARCH 2016
a - Tilt tube
b - Nut
d
c - Power trim harness clamps
d - Power trim harness
e - Port clamp bracket
f - Transom bolt (2 per clamp bracket)
g - Lower pivot pin washer and snap ring
g
19391
© 2016 Mercury Marine
Clamp/Swivel Bracket, Driveshaft Housing
a - Steering shaft
b - Swivel bracket
c - Bushing
d - O‑ring
e - Washer
19381
Page 5A-37