Mercury 25 EFI Service Manual page 352

Clamp/Swivel Bracket, Driveshaft Housing
2. Remove the spring and pivot guide from the swivel bracket.
Reassembly and Installation
1. Install a new plastic bushing on the tilt stop pivot shaft. Position the bushing as shown.
2. Install a new pivot guide and spring in the swivel bracket. Lubricate the guide with 2‑4‑C with PTFE.
Tube Ref No.
2-4-C with PTFE
95
3. Position the tilt stop bracket so the pin is between the reverse lock lever stops.
Page 5A-46
a
a
Description
© 2016 Mercury Marine
a -
b -
b
20838
a
b
a - Spring
b - Pivot guide
b
20848
Where Used
Tilt stop bracket pivot guide
Tilt stop plate
Bolts
a - Plastic bushing
b - Tilt stop pivot shaft
20846
92-802859A 1
90-8M0105568 eng MARCH 2016
Part No.