Power Trim
8.
Secure the motor assembly to the power trim pump and cylinder assembly with two cross slotted screws. Tighten the
screws to the specified torque.
d
Description
Trim motor mounting screws
9.
Install the reservoir tank over the electric motor and onto the pump assembly.
10. Install two 4 mm internal hex screws. Tighten the screws to the specified torque.
11. Secure the wire harness to the reservoir tank with a cable tie.
12. Fill the power trim system with Power Trim and Steering Fluid.
13. Install the reservoir tank fill plug.
d
Description
Reservoir mounting screws
Tube Ref No.
Power Trim and Steering
114
Fluid
14. Install the power trim assembly to the outboard. Refer to Power Trim Installation.
Page 5B-30
a -
Electric motor assembly
b -
O‑ring
c -
Power trim pump and cylinder assembly
d -
Electric motor wire harness
a
b
c
10957
a
a -
Reservoir tank
b -
Fill plug
c -
Cable tie
d -
Reservoir tank mounting screws (4 mm internal hex)
b
c
10954
Description
© 2016 Mercury Marine
Nm
5.2
Nm
5.2
Where Used
Power trim system
90-8M0105568 eng MARCH 2016
lb. in.
lb. ft.
46
lb. in.
lb. ft.
46
Part No.
92-858074K01