Mercury 25 EFI Service Manual page 388

Power Trim
3. Attach the motor assembly to the power trim pump and cylinder assembly.
NOTE: Position the trim motor assembly with the wire harness next to the trim cylinder.
4. Install an O‑ring on the electric motor bracket.
d
Description
Electric motor mounting screws
5. Install the reservoir tank over the electric motor and onto the pump and cylinder assembly.
6. Install two 4 mm internal hex screws. Tighten screws to the specified torque.
7. Secure the wire harness to the reservoir cover with a cable tie.
8. Fill the power trim system with Power Trim and Steering Fluid.
d
Description
Power trim reservoir tank attaching screws (4 mm internal hex)
Tube Ref No.
Power Trim and Steering
114
Fluid
Page 5B-26
a - Electric motor assembly
b - O‑ring
c - Power trim pump and cylinder assembly
d - Electric motor wire harness
a
b
c
10957
a
a - Reservoir tank
b - Fill plug
c - Cable tie
d - Reservoir tank mounting screws (4 mm internal hex)
b
c
10954
Description
© 2016 Mercury Marine
Nm
Nm
Where Used
Power trim system reservoir
90-8M0105568 eng MARCH 2016
lb. in. lb. ft.
5.2 46
lb. in. lb. ft.
5.2 46
Part No.
92-858074K01