Mercury 25 EFI Service Manual page 138

Charging and Starting System
14. Install the plugged black wire and the plugged brown wire connectors into the wire connector retainer.
a
b
c
d
e
15. Install the starter cable to the starter solenoid. Protect the starter cable connection with the rubber boot.
16. Push the fuse power wire terminal and the power trim solenoid power wire terminal, through the battery positive cable
protection boot.
a
17. Secure the positive battery cable, fused power wire, and the trim solenoid power wire to the starter solenoid with a bolt and
washer. Tighten the bolt to the specified torque.
18. Secure the negative battery cable and the engine harness ground wire to the starter with a bolt and washer. Tighten the
bolt to the specified torque.
Page 2B-26
a - Battery positive
b
b - Fused power wire
c - Trim solenoid power wire
c
20892
© 2016 Mercury Marine
a - Plugged brown wire (ignition stop
f
tiller handle)
b - TPS connector
c - Plugged black wire
d - Low oil pressure wire (LT green)
e - Low oil pressure wire (white/red)
f - Two red wire connectors (one male,
one female)
g - Starter relay exciter wire (green)
g
h - Positive battery cable
h
20889
90-8M0105568 eng MARCH 2016