Swivel Bracket/Clamp Bracket Removal - Mercury 25 EFI Service Manual

Hide thumbs Also See for 25 EFI:
Table of Contents

Advertisement

Clamp/Swivel Bracket, Driveshaft Housing
5.
Attach the ground cable with a bolt to the swivel bracket. Tighten the bolt to specified torque.
Description
Ground cable bolt
6.
Ensure that the tilt lock lever is positioned as shown.
7.
Align the lower pivot pin and power trim unit with the starboard clamp bracket bore.
8.
Push the clamp bracket towards the swivel bracket while inserting the lower pivot pin through the starboard clamp bracket.
9.
Fully thread the starboard tilt tube nut on the tilt tube.
10. Push the tilt tube to the port side until it seats in the hex cavity in the clamp bracket.
11. Tighten the port tilt tube nut to specified torque.
12. Install a bushing, washer, and snap ring on the lower pivot pin.
e
d
c
Description
Port tilt tube nut
13. Reinstall the transom bolts through the starboard clamp bracket.

Swivel Bracket/Clamp Bracket Removal

Power Trim Models
1.
Remove the electrical plate cover and disconnect the power trim wires from the solenoids.
2.
Pull the wire harness through the bottom cowl.
Page 5A-34
a
a
a -
b -
c -
d -
e -
b
19220
© 2016 Mercury Marine
a -
b -
c -
d -
b
c
d
19217
Starboard tilt tube nut
Starboard clamp bracket
Lower pivot pin, bushing, washer, and snap ring
Tilt pin
Tilt lock lever
Ground cable and bolt
Washer
Tilt tube
Starboard clamp bracket
Nm
lb. in.
6
53
Nm
lb. in.
24
90-8M0105568 eng MARCH 2016
lb. ft.
lb. ft.
17.7

Advertisement

Table of Contents
loading

This manual is also suitable for:

30 efi25 efi jet

Table of Contents