Mercury 25 EFI Service Manual page 485

9. Remove the washer and bushing.
10. Remove the throttle handle while pulling the throttle shaft/grip and pushing on the throttle shaft friction control knob.
11. Remove the throttle cable pulley housing.
12. Remove the rubber grip from the throttle handle. Use a flat tip screwdriver to pry/push the rubber grip off the throttle
handle.
13. Remove the stop button and wires.
14. Remove the throttle shaft friction control knob assembly.
90-8M0105568 eng MARCH 2016
c
b
a
b
a
b
b
d
e
f
2993
a c
2994
2997
a
2998
© 2016 Mercury Marine
Tiller Handle
a - Throttle shaft retainer screw
b - Throttle shaft bracket
c - Throttle shaft friction control knob
and clamp assembly
d - Throttle cable pulley housing
e - Washer
f - Bushing
a - Throttle shaft friction control
knob
b - Throttle shaft/grip
c - Throttle cable pulley housing
a - Throttle handle
b - Rubber grip
a - Stop button/wire assembly
b - Throttle shaft friction
control knob and clamp
assembly
Page 7B-13