Mercury 25 EFI Service Manual page 147

14. Tighten the bolt securing the fuel cooler mounting bracket and the bolt securing the air vent assembly to the cylinder block
to the specified torque.
a
b
Description
Bolt (2)
15. Connect the engine harness water temperature sensor connector to the water temperature sensor.
16. Connect the engine harness ignition coil connectors to the three ignition coils.
17. Connect the engine harness MAP sensor connector to the MAP sensor.
18. Connect the engine harness trigger connector to the trigger.
19. Connect the engine harness ignition charge connector to the stator.
90-8M0105568 eng MARCH 2016
a - Air vent assembly
b - Fuel cooler
c
c - Bolt securing the air vent assembly to the cylinder block
d - Bolt securing the fuel cooler mounting bracket to the
cylinder block
d
21192
a -
a
b -
b
21189
© 2016 Mercury Marine
Charging and Starting System
Nm lb. in.
6
Water temperature sensor
Ignition coil harness connectors (3)
lb. ft.
53
Page 2B-35