Mercury 25 EFI Service Manual page 139

19. Secure the engine harness with the clamp.
d
c
Description
Bolt (battery positive and negative cables)
20. Route the engine harness on the port side of the engine.
21. Connect the trigger harness connector to the engine harness.
22. Connect the oil pressure sender harness connector to the engine harness.
23. Connect the engine harness high pressure fuel pump connector to the VST.
24. Bend the clamp to secure the trigger harness connector and the oil sender harness connector.
25. Use a cable tie to secure the air vent assembly vent hose to the engine harness. Do not collapse the air vent assembly
hose with the cable tie.
e
d
26. Install the fuel cooler mounting bracket to the cylinder block and secure with a boLT Do not tighten the bolt at this time.
27. Install the air vent assembly to the top of the fuel cooler mounting bracket.
90-8M0105568 eng MARCH 2016
a
a - Clamp securing the engine harness
b - Negative battery cable and engine harness
ground wire
c - Positive battery cable, fuse power wire, trim
solenoid power wire
b
d - Starter cable
10480
a - Cable tie securing the air vent assembly vent hose
b - High pressure fuel pump harness connector
c - Clamp
d - Trigger harness connector
e - Oil pressure sender harness connector
a
b
c
10468
© 2016 Mercury Marine
Charging and Starting System
Nm lb. in. lb. ft.
6 53
Page 2B-27