Mercury 25 EFI Service Manual page 489

9. Align the throttle shaft friction control knob assembly with slot in the tiller handle. Install the throttle shaft friction control
knob in the tiller handle.
d
10. Turn the throttle handle to the neutral position. The cable ends should be equal in length to ensure alignment of the throttle
shaft and the cable pulley.
11. Insert the throttle shaft into the throttle cable pulley housing.
12. Route the stop button wires around the notch in the throttle cable pulley housing.
13. Install a washer and bushing on the tiller handle.
90-8M0105568 eng MARCH 2016
a
c
b a
b
a
e
3139
a - Neutral position on throttle handle
b - Throttle position mark
c - Cable ends of equal length
c
3145
© 2016 Mercury Marine
Tiller Handle
a - Stop button wires
b - Throttle cable pulley housing
c - Throttle shaft
d - Throttle shaft friction control
knob assembly
e - Throttle cables
Page 7B-17