Mercury 25 EFI Service Manual page 335

2. Remove the transom bolts from the port clamp bracket.
g
d
3. Remove the electrical plate cover and disconnect the power trim wires from the solenoids.
4. Remove the two harness clamps securing the power trim wire harness to the clamp bracket and pull the wire harness
through the clamp bracket.
5. Remove the tilt tube nut from the port side.
6. Remove the snap ring and washer from the port end of the lower pivot pin.
7. Push the lower pivot pin through the port clamp bracket.
c
b
a
8. Remove the port clamp bracket.
9. Inspect the bushings and washers. Replace if required.
90-8M0105568 eng MARCH 2016
e
g
b
a
a
a -
b -
c -
d -
d
e -
f -
e
f
19142
Clamp/Swivel Bracket, Driveshaft Housing
g
f
c
b
a -
b -
20926
Port clamp bracket
Tilt tube nut
Power trim harness
Harness clamps (2)
Tilt pin and cotter pin
Lower pivot pin, bushing, washer, and snap ring
© 2016 Mercury Marine
a - Bolt and ground cable
b - Anode
c - Bolt
d - Port clamp bracket
e - Lower pivot pin
f - Starboard clamp bracket
g - Bushing
19141
Green heavy gauge pump wire/green
relay terminal (down)
Blue heavy gauge pump wire/blue relay
terminal (up)
Page 5A-29