Mercury 25 EFI Service Manual page 201

5. Insert the cowl latch lever through the cowl latch seal.
a
6. Insert the cowl latch pivot rod into the cowl latch. The cowl latch pivot rod end with two holes must be on the starboard side
of the cowl.
7. Push the cowl latch pivot rod through the cowl latch lever and the cowl latch seal.
8. Center the cowl latch pivot rod bolt holes with the lower cowl threaded holes.
9. Install four washers (two each side) between the cowl latch pivot rod and the lower cowl.
NOTE: Some models do not have washers between the cowl latch pivot rod and the lower cowl.
10. Install the cowl latch pivot rod detent spring and bolts. Tighten the bolts to the specified torque.
c
Description
Bolt securing cowl latch pivot rod (2)
90-8M0105568 eng MARCH 2016
b
11612
b
a
a
b
a - Cowl latch lever
b - Cowl latch seal
a - Washer (4)
b - Cowl latch pivot rod two holes
11615
a - Bolt securing cowl latch pivot rod (2)
b - Cowl latch detent spring
c - Cowl latch lever
11610
© 2016 Mercury Marine
Service Procedures
Nm lb. in. lb. ft.
6 53
Page 3C-17