Mercury 25 EFI Service Manual page 148

Charging and Starting System
20. Secure the ignition charge connector, trigger connector, and the alternator connector to the engine wire harness with three
cable ties.
b
a - Cable ties (3)
b - Ignition charge connector
c - Trigger connector
d - MAP sensor connector
e - Alternator connector
21. Connect the engine harness connector to the ECU.
22. Connect the engine harness fuel injector connectors to the three fuel injectors.
a
23. Install the electrical cover and secure with two bolts, washers, and spacers. Tighten the bolts to the specified torque.
a
Description
Bolts (2)
24. Install the recoil assembly and timing belt cover. Refer to Section 8A ‑ Manual Starter.
Page 2B-36
c
e
a
b
21186
© 2016 Mercury Marine
d
a - Fuel injector harness connectors (3)
b - ECU harness connector
a - Grommets in the intake manifold
b - Bolts and spacers securing the electrical
cover (2)
b
10493
Nm
6
90-8M0105568 eng MARCH 2016
21187
lb. in. lb. ft.
53