6.
Use a torch lamp to warm the bottom yoke.
7.
Use a dead blow hammer to remove the bottom yoke from the steering shaft assembly.
Torch Lamp
8.
Wait until the steering shaft is cool.
9.
Remove the washer, O‑ring, and bushing from the steering shaft.
10. Remove the steering shaft from the swivel bracket.
11. Remove the clamp brackets from the swivel bracket. Refer to Clamp Bracket Removal, preceding.
Reassembly
1.
Assemble the clamp brackets to the swivel bracket. Refer to Clamp Bracket Installation, preceding.
2.
Install a thrust washer and bushing on the steering arm.
90-8M0105568 eng MARCH 2016
a
c
a
b
c
© 2016 Mercury Marine
Clamp/Swivel Bracket, Driveshaft Housing
a -
Dead blow hammer
b -
Torch lamp
c -
Bottom yoke
b
20901
91‑63209
a -
Steering shaft
b -
Swivel bracket
c -
Bushing
d -
O‑ring
e -
Washer
d
e
20902
Page 5A-51