Recoil Starter Assembly - Mercury 25 EFI Service Manual

Recoil Starter
8. Pinch the recoil lock retainer and push the recoil lock out of the recoil housing.
a
9. Remove the E‑ring securing the starter pawl to the starter sheave.
10. Push the starter pawl out of the starter sheave.

Recoil Starter Assembly

Uncontrolled release of the rewind spring can cause serious injury. Wear eye protection when servicing the rewind starter in
case spring should uncoil.
1. Lubricate with 2‑4‑C with PTFE the area of the recoil housing where the recoil spring is located.
2. Install the recoil spring into the recoil housing.
a
Tube Ref No.
2-4-C with PTFE
95
3. Tie a knot on one side of the recoil rope and insert the recoil rope through the recoil sheave.
4. Thread the recoil rope through the recoil sheave as shown.
Page 8A-8
b
c
9723
b
9726
Description
© 2016 Mercury Marine
a - Recoil lock
b - Interlock lever spring
c - Recoil lock retainer (pinch to remove)
9725
WARNING
!
a - Recoil spring
b - Lubricate with 2‑4‑C with PTFE
Where Used
Recoil housing
Part No.
92-802859A 1
90-8M0105568 eng MARCH 2016