Power Trim Installation - Mercury 25 EFI Service Manual

4. Retract the power trim cylinder rod.
5. Disconnect the battery cables from the battery.
6. Disconnect the power trim electrical wires from the relays.
7. Remove the ground strap.
8. Remove the port side snap ring and washer from the power trim pivot pin.
d
9. Use a drift punch to remove the pivot pin from the power trim assembly.
10. Remove the power trim assembly from clamp brackets.

Power Trim Installation

1. Install the power trim assembly between the clamp brackets.
2. Install the lower pivot pin through the clamp brackets and power trim assembly.
3. Install the port side snap ring and washer to the power trim pivot pin.
d
4. Install the ground strap.
5. Connect the battery cables to the battery.
6. Extend the power trim cylinder rod until it aligns with the hole in the tilt bracket. Engage the tilt lock.
7. Push the trim cylinder rod pin through the bore from the port side.
90-8M0105568 eng MARCH 2016
a
b
c
10516
a
b
c
10516
© 2016 Mercury Marine
a - Snap ring
b - Pivot pin
c - Washer
d - Power trim assembly
a - Snap ring
b - Pivot pin
c - Washer
d - Power trim assembly
Power Trim
Page 5B-19