Mercury 25 EFI Service Manual page 344

Clamp/Swivel Bracket, Driveshaft Housing
f. Pull the harness through the hole in the clamp bracket.
g. Attach the two power trim harness clamps.
h. Install the tilt tube nut. Tighten the port side nut to the specified torque.
a
c
b
e
f
Description
Port tilt tube nut
Transom bolts
2. Install the thrust washer and bushing on the steering arm.
3. Install the steering shaft assembly in the swivel bracket.
b
c
d
4. Push the steering shaft assembly completely into the steering bracket.
Page 5A-38
a - Tilt tube
b - Nut
d
c - Power trim harness clamps
d - Power trim harness
e - Port clamp bracket
f - Transom bolt (2 per clamp bracket)
g - Lower pivot pin washer and snap ring
g
19391
a
a -
b -
c -
d -
19014
© 2016 Mercury Marine
Nm
24
68
Steering shaft assembly
Thrust washer
Bushing
Swivel bracket
90-8M0105568 eng MARCH 2016
lb. in. lb. ft.
17.7
50