Reverse Lock Lever; Tilt Stop Bracket - Mercury 25 EFI Service Manual

6. Install the reverse lock link in the bushing and reverse lock hook and snap the bushing closed
a - Bushing
b - Reverse lock link
c - Reverse lock hook
d - Upper shift shaft

Reverse Lock Lever

Removal
1. Remove the spring from the spring hook pin.
2. Remove the shoulder bolt.
a
f
e
Installation
1. Attach the reverse lock lever to the starboard clamp bracket with the shoulder bolt, two wave washers, and a flat washer.
Tighten the shoulder bolt to the specified torque.
Description
Reverse lock lever shoulder bolt
2. Attach the spring to the reverse lock lever and the spring hook pin.

Tilt Stop Bracket

Removal
1. Remove the two bolts securing the tilt stop plate to the swivel bracket.
90-8M0105568 eng MARCH 2016
a
b
b
c
d
Clamp/Swivel Bracket, Driveshaft Housing
c
a - Reverse lock lever
b - Shoulder bolt and washer between lever and swivel
bracket
c - Upper lever stop
d - Pin on tilt stop bracket
e - Spring hook pin
f - Spring
20834
© 2016 Mercury Marine
b
d
20928
Nm lb. in. lb. ft.
11 97.3
Page 5A-45