Description
Crank position sensor bolt (2)
6.
Install the flywheel. Refer to Flywheel Removal And Installation.
7.
Install the recoil assembly and timing belt cover. Refer to Section 8 ‑ Manual Starter.
Port CPS Installation
1.
Insert a bolt through the CPS ground wire.
2.
Secure the CPS with two bolts. Tighten the bolts to the specified torque.
3.
Connect the CPS harness connector to the engine harness connector.
4.
Secure the CPS wire harness to the engine wire harness with the clamp.
c
Description
Crank position sensor bolt (2)
5.
Install the flywheel. Refer to Flywheel Removal and Installation.
6.
Install the recoil assembly and timing belt cover. Refer to Section 8 ‑ Manual Starter.
90-8M0105568 eng MARCH 2016
a -
CPS harness connector
b -
Bolts securing CPS (2)
a
c -
CPS ground wire
b
16734
© 2016 Mercury Marine
Nm
lb. in.
lb. ft.
4
35.5
Nm
lb. in.
lb. ft.
4
35.5
Page 2A-17
Ignition