Mercury 25 EFI Service Manual page 92

Ignition
5. Remove the two bolts securing the CPS to the coil bracket.
a
Port Crank Position Sensor Removal
1. Remove the bolts securing the CPS to the coil bracket.
2. Disconnect the CPS harness connector from the engine harness connector.
3. Bend the clamp to remove the CPS wire harness.
c
Starboard CPS Installation
1. Install the clamp onto one of the CPS mounting bolts.
2. Install the bolt with the clamp on the forward mounting hole of the CPS.
3. Secure the CPS with two bolts. Tighten bolts to the specified torque.
4. Connect the CPS harness connector to the engine harness connector.
5. Secure the CPS wire harness to the engine harness with a cable tie.
a
Page 2A-16
a
b
16734
© 2016 Mercury Marine
a -
b -
b
16733
a - CPS harness connector
b - Bolts securing CPS (2)
c - CPS ground wire
a -
b -
b
22300
90-8M0105568 eng MARCH 2016
Bolts securing CPS (2)
Cable tie
Bolt with a clamp securing CPS
Cable tie