Table of Contents
Advertisement
Outboard Installation
Engine Center Line
Minimum
Top Cowl Removal and Installation
Top Cowl Removal
1.
Unlock the cowl latch located at the rear of the engine by lifting the latch up.
2.
Lift up on the rear of the cowl and disengage the front hook.
Top Cowl Installation
1.
Engage the front hook and push the top cowl onto the lower cowl.
2.
Push the cowl latch down to lock the cowl in place.
Lifting Outboard
Use the lifting eye located aft of the flywheel to support the engine when installing the outboard.
Drilling Outboard Mounting Holes (Manual Tilt Models)
IMPORTANT: Models not equipped with power trim or gas assist must have the transom clamps contacting the top of the
transom, and the clamp screws tightened, prior to drilling the mounting bolt holes through the transom.
1.
Place outboard on center line of transom.
Page 1D-4
© 2016 Mercury Marine
66 cm (26 in.)
10170
10111
27005
90-8M0105568 eng MARCH 2016
Advertisement
Chapters
Table of Contents
Troubleshooting
