Mercury 25 EFI Service Manual page 336

Clamp/Swivel Bracket, Driveshaft Housing
Port Clamp Bracket Installation
1. Install a washer on the tilt tube.
2. Install a bushing in the power trim unit.
3. Ensure that the tilt lock lever is positioned as shown.
a
b
c
d
4. Install the clamp bracket on the tilt tube.
5. Route the power trim harness through the clamp.
6. Attach the power trim harness clamps to the harness and attach to the clamp bracket.
7. Install the nut on the tilt tube.
8. Align the lower pivot pin with the clamp bracket and push the pin through the clamp bracket.
9. Install the bushing, steel washer, and snap ring on the lower pivot pin.
10. Tighten the tilt tube nut to specified torque.
c
b
a
Description
Tilt tube nut
Power trim harness clamp bolt
11. Route the power trim harness through the bottom cowl.
Page 5A-30
a -
b -
c -
d -
e -
f
f -
e
19176
a -
b -
c -
d -
d
e -
f -
e
f
19142
© 2016 Mercury Marine
Tilt tube
Washer
Power trim unit
Bushing
Lower pivot pin
Tilt lock lever
Port clamp bracket
Tilt tube nut
Power trim harness
Harness clamps (2)
Tilt pin with cotter pin
Lower pivot pin, bushing, washer, and snap ring
Nm lb. in.
24
6 53
90-8M0105568 eng MARCH 2016
lb. ft.
17.7