Mercury 25 EFI Service Manual page 358

Clamp/Swivel Bracket, Driveshaft Housing
3. Install the steering shaft assembly in the swivel bracket.
4. Push the steering shaft assembly completely into the steering bracket
5. Install a bushing, O‑ring, and thrust washer.
6. Align the bottom yoke on the steering shaft.
7. Warm the bottom yoke with the torch lamp.
8. Hold the steering shaft assembly.
9. Use a dead blow hammer to install the bottom yoke on the steering shaft assembly.
Torch Lamp
Page 5A-52
a
b
c
a
b
c
c
b
a
© 2016 Mercury Marine
d
20903
a - Steering shaft
b - Swivel bracket
c - Bushing
d - O‑ring
e - Washer
d
e
20902
a - Steering shaft assembly
b - Bottom yoke
c - Torch lamp
d - Dead blow hammer
d
20904
91‑63209
90-8M0105568 eng MARCH 2016
a - Steering shaft assembly
b - Thrust washer
c - Bushing
d - Swivel bracket