Clamp Bracket/Swivel Bracket - Power Trim And Gas Assist Models; Clamp Brackets - Removal And Installation - Mercury 25 EFI Service Manual

Clamp/Swivel Bracket, Driveshaft Housing
2. Attach the power trim harness clamps to the harness and attach to the clamp bracket.
c
b
a
3. Connect the blue and green wires to the solenoids.
4. Attach the electrical plate cover with two bolts. Tighten the bolts to specified torque.
Description
Electrical plate cover bolts
Clamp Bracket/Swivel Bracket ‑ Power Trim and Gas Assist Models
Clamp Brackets ‑ Removal and Installation
Port Clamp Bracket Removal
1. Remove the two bolts securing the anode to the clamp brackets.
Page 5A-28
a - Port clamp bracket
b - Tilt tube port side nut
c - Power trim harness
d - Harness clamps (2)
d
e - Tilt pin and cotter pin
f - Lower pivot pin, bushing, washer, and snap ring
e
f
19142
a
b
© 2016 Mercury Marine
a - Green heavy gauge pump wire/green
relay terminal (down)
b - Blue heavy gauge pump wire/blue relay
terminal (up)
20926
Nm
6
90-8M0105568 eng MARCH 2016
lb. in. lb. ft.
53