Charging and Starting System
2.
Remove the two bolts securing the MAP sensor bracket to the intake manifold.
3.
Cut the cable ties securing the voltage regulator/rectifier sensing lead connector to the engine harness. Disconnect the
sensing lead connector.
b
a
4.
Remove the two bolts securing the voltage regulator/rectifier to the intake manifold. Remove the voltage regulator/rectifier.
a
Voltage Regulator/Rectifier Installation
1.
Install the voltage regulator/rectifier ground wire eyelet onto one of the voltage regulator/rectifier mounting bolts.
2.
Install the bolt with the ground wire eyelet into the lower mounting hole of the voltage regulator/rectifier.
3.
Secure the voltage regulator/rectifier to the intake manifold. Do not tighten the bolt at this time.
4.
Install a bolt in the upper mounting hole of the voltage regulator/rectifier mounting hole and secure to the intake manifold.
Page 2B-16
a -
Cable tie securing the voltage regulator/rectifier stator connector
b -
Bolts securing the MAP sensor bracket (2)
a
b
20821
c
a -
Voltage regulator/rectifier ground wire
b
b -
Bolts securing the voltage regulator/rectifier (2)
20823
© 2016 Mercury Marine
a -
MAP sensor
b -
Voltage regulator/rectifier connector
c -
Cable ties securing the voltage regulator/
rectifier sensing lead connector
20822
90-8M0105568 eng MARCH 2016