Dryer; Blower Assembly; Removing The Blower Assembly - Kodak M6B Service Manual

Blower Assembly

Removing the Blower Assembly

[1] Remove the BLOWER MOTOR COVER from
the BLOWER DRIVE MOTOR.
[2] Remove the 3 MOUNTING BOLTS from the

BLOWER ASSEMBLY.

[3] Remove the BLOWER DRIVE BELT.
[4] Remove the BLOWER ASSEMBLY.
BLOWER
DRIVE BELT
PULLEY
BLOWER
ASSEMBLY
BLOWER
MOUNTING
BOLT (3)
Figure 24 Removing the Blower Assembly
246628
BLOWER
MOTOR
COVER
SCREW
WASHER
BLOWER
DRIVE
BELT
BLOWER
DRIVE
MOTOR
H108_0072CCC
H108_0072CA
SECTION 3

Dryer

[5] Loosen the 2 SETSCREWS to remove the
PULLEY from the BLOWER ASSEMBLY.
[6] Install the PULLEY onto the new BLOWER
ASSEMBLY.
[7] Install the new BLOWER ASSEMBLY using
the 3 MOUNTING BOLTS from Step 2.
[8] Loosen the BLOWER DRIVE MOTOR
MOUNTING BOLTS.
[9] Install the BLOWER DRIVE BELT.
[10] Adjust the position of the BLOWER DRIVE
MOTOR to obtain the correct tension and
alignment of the BLOWER DRIVE BELT. See
Figure 25.
[11] Install the BLOWER MOTOR COVER.
Correct tension is achieved when the
BLOWER DRIVE BELT does not make
loud noises when you energize the
processor.
Figure 25 Adjusting for Correct Tension and
NOTE
Alignment of the Blower Drive Belt
H048_0151AA
2-19