Table of Contents
Advertisement
ADJUSTMENTS
13
. Fasten BRACKET SCREWS.
14
. Rotate GAIN CONTROL counter clockwise until LED lights red.
15
. Rotate GAIN CONTROL 2 steps clockwise.
16
. Close CASSETTE and remove it from the ML 700.
17
. Check the adjustment with a CASSETTE 35 x 43 cm.
18
.
TYPE 2 SENSOR
19
. Feed in a TYPE 2 CASSETTE
20
. Select Option 7.2 (ALIGN CASSETTE). Centre CASSETTE.
21
. Repeat STEP 6 to 16.
22
. Check the adjustment with another TYPE 2 CASSETTE.
23
. Key in 3585 to bring all MOTORS to HOME POSITION.
FILM OUT OF CASSETTE SENSOR B6 (FOC)
ML700 only (old style version)
PURPOSE:
To set the sensitivity of the SENSOR to give correct output when it is covered by a FILM.
1
.
Connect positive lead of DVM to Pin 11of U1 on PCB A9. Connect negative lead of
DVM to TP2 of PCB A9.
2
.
Without a FILM the voltage reading should be + 0.7V. If the voltage is higher readjust
the mechanical position of SENSOR B6 (FO).
3
.
Connect positive LEAD of DVM to PIN 10 of U1 on PCB A9
4
.
Cover SENSOR B6 with a film and adjust R27 to +0.9V.
KODAK AG, Stuttgart
4-51
3053-3
12/1998
Advertisement
Table of Contents
