Engine Mount, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
❑ Tightening specification and sequence. Refer to
⇒ 2.4 Pendulum Support, Removing and Installing , page 33
10 - Bolt
❑ Replace after removing
❑ Tightening specification and sequence. Refer to
⇒ 2.4 Pendulum Support, Removing and Installing , page 33
11 - Bolt
❑ Replace after removing
❑ Tightening specification and sequence. Refer to
⇒ 2.4 Pendulum Support, Removing and Installing , page 33
12 - Bolt
❑ 60 Nm + 90° turn
❑ Replace after removing
13 - Bolt
❑ 60 Nm + 90° turn
❑ Replace after removing
14 - Transmission Mount
❑ With support arm
❑ Removing and installing. Refer to
15 - Bolt
❑ 50 Nm + 90° turn
❑ Replace after removing
2.2

Engine Mount, Removing and Installing

Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Bolts - Engine Mount
– Disconnect the connector -1-.
– Free up the hoses -2-.
– Release the retainers with a screwdriver in direction of
-arrow- and move the coolant expansion tank to the side.
– Support the engine in its installed position. Refer to
⇒ 2.5 Engine, Supporting in Installed Position , page 33
– Slightly pretension the engine/transmission assembly with the
spindle, do not lift.
30
Rep. Gr.10 - Engine Assembly
⇒ 2.3 Transmission Mount, Removing and Installing , page 31
.
.
.
.
.