Heated Oxygen Sensor; Overview - Heated Oxygen Sensor; Oxygen Sensor 1 Before Catalytic Converter Gx10 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

8

Heated Oxygen Sensor

⇒ 8.1 Overview - Heated Oxygen Sensor , page 333
⇒ 8.2 Oxygen Sensor 1 before Catalytic Converter GX10 , Re‐
moving and Installing , page 333
⇒ 8.3 Oxygen Sensor 1 after Catalytic Converter GX7 , Remov‐
ing and Installing , page 334
8.1

Overview - Heated Oxygen Sensor

Oxygen Sensor Electrical Connectors
1 - Oxygen Sensor 1 after Catalytic Converter - GX7- connector
2 - Oxygen Sensor 1 before Catalytic Converter - GX10- connec‐
tor
Oxygen Sensor 1 before Catalytic Converter - GX10- -1-
Oxygen Sensor 1 after Catalytic Converter - GX7- -1-
Tightening Specifications
Component
Heated Oxygen Sensor
Note
Coat new oxygen sensors with an assembly paste. This paste
♦
must not come into contact with oxygen sensor slots.
For a used oxygen sensor, only coat threads with hot bolt
♦
paste. This paste must not come into contact with oxygen
sensor slots. Hot bolt paste. Refer to the Parts Catalog
The oxygen sensor wire must always be attached at the same
♦
location when installing. Do not let the electrical wire connec‐
tion come in contact with the exhaust pipe.
8.2 Oxygen Sensor 1 before Catalytic Con‐
verter - GX10- , Removing and Installing
Special tools and workshop equipment required
♦ Ring Wrench 7-Piece Set - 3337-
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
.
.
Tightening Specification
55 Nm
Golf 2015 ➤ , Golf Variant 2015 ➤
.
333
8. Heated Oxygen Sensor