Volkswagen Golf 2015 Repair Manual page 163

– Apply the sealant on the clean sealing surface of the cylinder
head cover as illustrated -arrows-.
♦ Sealant bead thickness: 2 to 3 mm.
– Secure the camshaft and place the cylinder head cover with
the camshaft on the cylinder head.
– Lightly push on the cylinder head cover by hand and while
doing this turn the camshaft slightly until the cylinder head
cover lays free of tension on the cylinder head.
– Replace the cylinder head cover bolts.
– Tighten the bolts in several steps, tightening sequence. Refer
to
⇒ Fig. Cylinder Head Cover Tightening Sequence ,
page 135 .
Note
Pay attention that the cylinder head cover is not tilted.
– Turn the intake camshaft with the Adapter - T40266- in the
direction of the -arrow A- until the markings -1 and 2- align.
Push the Camshaft Lock - Component 2 - T40271/2- in the
chain sprocket splines in direction of -arrow B-.
– Turn the exhaust camshaft with the Adapter - T40266- in the
direction of -arrow A- until the markings -1 and 2- align. Push
the Camshaft Lock - Component 1 - T40271/1- in the chain
sprocket splines -B-. The mark -2- is offset slightly to the right.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Golf 2015 ➤ , Golf Variant 2015 ➤
155
4. Valvetrain