Fan Shroud, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Installing
– If there are small impressions on the fins, pay attention to the
following. Refer to
⇒ 3.5 Cooler and Condenser Assembly , page 6
– Replace the O-rings.
– Place the radiator at an angle in the lower charge air cooler
mount and engage the radiator with each other -arrow-. Pull
to make sure the catch is secure.
– Install the fan shroud. Refer to
⇒ 4.5 Fan Shroud, Removing and Installing , page 249
– Connect the coolant hose to the coupling. Refer to
⇒ Fig. Connect the Coolant Hose to the Coupling ,
page 245 .
– Fill with coolant. Refer to
Note
All of the coolant must be changed if the radiator was replaced.
Tightening Specifications
♦ Refer to ⇒ 4.1 Overview - Radiator/Coolant Fan , page 244
4.5

Fan Shroud, Removing and Installing

Removing
– Remove the air filter housing. Refer to
⇒ 3.2 Air Filter Housing, Removing and Installing ,
page 294 .
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Loosen the hose clamps -arrows- and remove the left charge
air hose -A-.
CAUTION
There is a risk of injury if the radiator fan turns on by itself.
– Disconnect the connectors.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
⇒ page 222 .
Golf 2015 ➤ , Golf Variant 2015 ➤
.
.
.
249
4. Radiator/Coolant Fan