Oxygen Sensor 1 After Catalytic Converter Gx7 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
The Oxygen Sensor 1 before Catalytic Converter - GX10- is com‐
posed of:
♦ Heated Oxygen Sensor - G39-
♦ Oxygen Sensor Heater - Z19-
Removing
– Disconnect the connector -2- of the Oxygen Sensor 1 before
Catalytic Converter - GX10- .
– Remove the Oxygen Sensor 1 before Catalytic Converter -
GX10- -1- using a tool from the Ring Wrench 7-Piece Set -
3337- .
Installing
Note the following when installing:
Note
Coat new oxygen sensors with an assembly paste. This paste
♦
must not come into contact with oxygen sensor slots.
For a used oxygen sensor, only coat threads with hot bolt
♦
paste. This paste must not come into contact with oxygen
sensor slots. Hot bolt paste. Refer to the Parts Catalog.
The oxygen sensor wire must always be attached at the same
♦
location when installing. Do not the electrical wire connection
come in contact with the exhaust pipe.
Tightening Specifications
♦ Refer to
⇒ 8.1 Overview - Heated Oxygen Sensor , page 333
8.3 Oxygen Sensor 1 after Catalytic Con‐
verter - GX7- , Removing and Installing
The Oxygen Sensor 1 after Catalytic Converter - GX7- is com‐
posed of:
♦ Oxygen Sensor after Three Way Catalytic Converter - G130-
♦ Heater For Oxygen Sensor 2 after Catalytic Converter - Z30-
Special tools and workshop equipment required
♦ Ring Wrench 7-Piece Set - 3337-
334
Rep. Gr.24 - Multiport Fuel Injection
.