Volkswagen Golf 2015 Repair Manual page 59

Install Vibration Damper
– If necessary remove the Collar Nut -B- and the Assembly Tool
- Turning Over Tool -A- from the tensioning pins.
– Secure the vibration damper in TDC, while doing this pay at‐
tention to the tooth contour of the chain sprocket -arrow-.
– Place the Assembly Tool - Turning Over Tool -A- on the ten‐
sioning pins the at the same time the hex fitting points to the
vibration damper.
– Install the Collar Nut -B-, while doing this move the vibration
damper slightly back and forth, to check in the vibration damp‐
er is correctly in the tooth contour. Tighten the collar nut, until
the vibration damper can no longer be turned.
– Place the Counterhold Tool - T10531/1- as shown on the vi‐
bration damper and tighten hand-tight using the knurled bolt
-arrows-.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Golf 2015 ➤ , Golf Variant 2015 ➤
1. Cylinder Block, Belt Pulley Side
51