Volkswagen Golf 2015 Repair Manual page 121

♦ Seal - Vibration Damper
Removing
– Remove the vibration damper. Refer to
⇒ 1.4 Vibration Damper, Removing and Installing , page 47
• The Tensioning Pins - T10531/2- is installed.
– Remove the seal -arrow- with the Seal Installer - Crankshaft -
T40274- .
Installing
– Clean the running and sealing surface.
– Push the seal -arrow- on the Seal Installer - Crankshaft -
T10354- .
• The closed side of the seal points to the Seal Installer - Crank‐
shaft - T10354- .
– Push the seal -arrow- with the Seal Installer - Crankshaft -
T10354- on the Tensioning Pins - T10531/2- and place on the
lower timing chain cover.
– Additional attach the Press Piece - Gearbox - T10375- and
tighten the Knurled Nut - T10531/4- .
– Drive the seal in all the way using the Seal Installer - Crank‐
shaft - T10354- .
Note
Replace the vibration damper bolt.
♦
Replace the O-ring.
♦
Assemble in reverse order of disassembly. Note the following:
– Install the vibration damper. Refer to
⇒ 1.4 Vibration Damper, Removing and Installing , page 47
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Golf 2015 ➤ , Golf Variant 2015 ➤
.
.
2. Timing Chain Cover
113