Volkswagen Golf 2015 Repair Manual page 244

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
– Lift the clamp -1-, remove the upper coolant supports and set
them aside.
– Disconnect the connector -1- from the Oil Pressure Switch
-2-.
– Remove the bolts -arrows- and remove the toothed belt cover.
Note
The drive gear bolt has a left thread.
– Counterhold the vibration damper and remove the bolt from
the coolant pump the drive wheel -1- by loosening three turns.
Use Torque Wrench 1410 - VAG1410- and Torque Wrench
1331 Insert - Ring Wrench - 12mm - T10360- .
Note
If on vehicles with a manual transmission a starter bolt hinders
attaching the tool, remove the bolt approximately 15 mm.
– Remove the toothed belt -2-.
Installing
Install in reverse order of removal. Note the following:
– Replace the bolt for the drive wheel.
– Drive gear installation position: the collar on the drive gear
faces the transmission.
– Position the toothed belt and tighten the bolts.
– Fill with coolant. Refer to
Tightening Specifications
♦ Refer to
⇒ 2.1 Overview - Coolant Pump/Thermostat , page 223
♦ Refer to ⇒ 3.1 Overview - Air Filter Housing , page 293
236
Rep. Gr.19 - Cooling System
⇒ page 218 .