Volkswagen Golf 2015 Repair Manual page 125

1 - Guide Pin
❑ 20 Nm
2 - Tensioning Rail
❑ For the timing chain
3 - Balance Shaft
❑ Exhaust side
❑ Must be replaced after
removing
❑ Lubricate the bearing
with engine oil
❑ Replacing. Refer to
⇒ 4.2.2 Balance Shaft
Exhaust Side, Remov‐
ing and Installing , page
73 .
4 - Guide Pin
❑ 20 Nm
5 - Guide Rail
❑ For the timing chain
6 - Chain Tensioner
❑ 85 Nm
❑ Install with locking fluid.
Refer to the Parts Cata‐
log.
7 - Seal
8 - Cylinder Block
9 - O-Ring
❑ Coat with engine oil
10 - Mounting Pin
❑ Lubricate with engine oil
❑ Installed position. Refer to
11 - Intermediate Sprocket
❑ The intermediate sprocket must be replaced if the bolt -item 13-
12 - Thrust Washer
13 - Bolt
❑ Replace after removing
❑ The intermediate sprocket -item 11-
❑ Tightening sequence. Refer to
14 - Guide Rail
❑ For balance shaft timing chain
15 - Guide Pin
❑ 20 Nm
16 - Balance Shaft
❑ Intake side
❑ Must be replaced after removing
❑ Lubricate the bearing with engine oil
❑ Replacing. Refer to
17 - Three Stage Chain Sprocket
❑ Installed position. Refer to
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
⇒ Fig. Mounting Pins - Installation Position , page 118
⇒ Item 11 (page 117)
⇒ Fig. Intermediate Sprocket Tightening Sequence , page 118
⇒ 4.2.1 Balance Shaft Intake Side, Removing and Installing , page 70
⇒ Fig. Three Stage Chain Sprocket - Installed Position , page 116
Golf 2015 ➤ , Golf Variant 2015 ➤
⇒ Item 13 (page 117)
must be replaced if the bolt is loosened.
is loosened.
.
117
3. Chain Drive