Volkswagen Golf 2015 Repair Manual page 127

♦ Tensioning Pins - T10531/2-
♦ Turning Over Tool - T10531/3-
♦ Collar Nut - T10531/4-
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Bolts - Bearing Bracket
♦ Bolt - Intermediate Sprocket
Removing
– Support the engine in its installed position. Refer to
⇒ 2.5 Engine, Supporting in Installed Position , page 33
– Remove the engine bracket. Refer to
⇒ 2.2 Engine Mount, Removing and Installing , page 30
– Remove engine support. Refer to
⇒ 1.6 Engine Support, Removing and Installing , page 55
– Remove timing chain upper cover. Refer to
⇒ 2.2.1 Upper Timing Chain Cover, Removing and Installing ,
page 106 .
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Remove the right wheel housing liner front section. Refer to ⇒
Body Exterior; Rep. Gr. 66 ; Wheel Housing Liner; Front
Wheel Housing Liner, Removing and Installing .
– Turn the vibration damper with the Counterhold - Vibration
Damper - T10355- to the Top Dead Center (TDC) point .
• The markings -1- on the camshaft chain sprockets must be
opposite the markings -2 and 3-.
• The notch on the vibration damper and the marking on the
lower cover for timing chain -arrow- must be opposite one an‐
other.
– Remove the lower timing chain cover. Refer to
⇒ 2.2.2 Lower Timing Chain Cover, Removing and Installing ,
page 108 .
Note
The pilot valve has left-hand threads.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Golf 2015 ➤ , Golf Variant 2015 ➤
.
.
.
119
3. Chain Drive