– Position the Seal Installer - Sealing Flange Guide Sleeve -
T20097- on the crankshaft pins -A-.
– Lightly coat the seal with engine oil.
– Slide the sealing flange onto the crankshaft pins with the Seal
Installer - Sealing Flange Guide Sleeve - T20097- .
– Tighten the new bolts in evenly in the sequence shown:
Step
Bolts
1.
-1 to 6-
2.
-1 to 6-
Note
Only six bolts are installed, two bolt openings remain open.
♦
After installing sealing flange, the sealant must dry for approx‐
♦
imately 30 minutes. Only after then may the engine oil be
replenished.
Assemble in reverse order of disassembly.
Tightening Specifications
♦ Refer to
⇒ 2.1 Overview - Cylinder Block, Transmission Side ,
page 57
.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Tightening Specification/Additional
Turn
Install all the way in by hand.
9 Nm
Golf 2015 ➤ , Golf Variant 2015 ➤
2. Cylinder Block, Transmission Side
61