Volkswagen Golf 2015 Repair Manual page 300

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Note
Fill the ultrasonic device up to the upper edge of the holes with
♦
cleaner (see the magnified area of the illustration).
Observe the safety precautions and the operating instructions
♦
for the ultrasonic device.
Cleaning
– Remove the fuel injectors. Refer to
⇒ 2.2 Fuel Injectors, Removing and Installing , page 285
– The ultrasonic device must be filled with cleaning fluid.
– Install the combustion chamber fuel injectors -1- all the way
into the Mounting Plate for Injection Modules - VAS6418/1-
-2-.
– Dip the combustion chamber fuel injectors into the cleaner with
the Mounting Plate for Injection Modules - VAS6418/1- .
– Set the temperature control -4- to 50 °C (122 °F).
– Set the time control -5- to 30 minutes.
– Turn on the ultrasonic device -3-.
Note
The time begins counting down once the cleaning temperature
reaches 50 degrees.
– Always replace the combustion chamber seal (Teflon seal) af‐
ter cleaning each combustion chamber fuel injector. Refer to
⇒ 2.4 Fuel Injector Seals, Replacing , page 288
– Install the combustion chamber fuel injectors. Refer to
⇒ 2.2 Fuel Injectors, Removing and Installing , page 285
292
Rep. Gr.24 - Multiport Fuel Injection
.
.
.